Message Lists - Sony VPL-BW7 Mode D'emploi

Indicators
Symptom
The LAMP/COVER
indicator flashes in
orange. (Repetition rate
of 2 flashes)
The LAMP/COVER
indicator flashes in
orange. (Repetition rate
of 3 flashes)
/
: 1 switch flashes in
red. (Repetition rate of 2
flashes)
/
: 1 switch flashes in
red. (Repetition rate of 4
flashes)
/
: 1 switch flashes in
red. (Repetition rate of 6
flashes)

Message Lists

Warning Message
Message
Please replace the Lamp
and clean the Filter.
Caution Message
Message
Not applicable!
48
GB
Cause and Remedy
• The lamp cover or the air filter cover is detached.
c Attach the cover securely (1 pages 49 and 51).
• The lamp has reached the end of its life.
c Replace the lamp (1 page 49).
• The lamp has reached a high temperature.
c Wait for 60 seconds until the lamp cools, then turn on the
power again.
• The internal temperature is unusually high.
c Check to ensure that nothing is blocking the ventilation holes.
• The projector is being used at a high altitude.
c Ensure that "High Altitude Mode" in the INSTALL SETTING
menu is set to "On."
The fan is broken.
c Consult with qualified Sony personnel.
Unplug the AC power cord from the wall outlet after the
switch stops flashing, plug the power cord to the wall outlet, then
turn the projector on again. If the
problem persists, the electrical system has failed.
c Consult with qualified Sony personnel.
Meaning and Remedy
• It is time to replace the lamp and clean the air filter.
c Replace the lamp (1 page 49) and clean the filter (1 page
51).
• When this message appears even after replacing the lamp, the
task has not been completed.
c Perform the operation of steps 10 to 13 on page 50.
Meaning and Remedy
You have pressed the wrong button.
c Press the appropriate button.
: 1
/ switch flashes in red and the
: 1
/