Sony VPL-GH10 Mode D'emploi page 47

Standby Mode
Power Saving
Lamp Setting
Lowers the power consumption in standby.
Standard 1: Sets power consumption to normal.
Standard 2: Sets the network function ineffective and power
consumption lower than "Standard 1."
Low: Sets power consumption lower than "Standard 2."
Note
When this item is set to "Low" or "Standard 2," the network function
will not operate in standby.
Sets the power saving mode.
When set to "On", the projector goes into power saving mode if no
signal is input for 10 minutes. At that time, the ON/STANDBY
indicator lights in orange, then the screen becomes dark. The power
saving mode is cancelled if a signal is input or any button on the
projector or the remote control is pressed. If you do not want to set
the projector to power saving mode, select "Off."
Selects this item after you have replaced the lamp.
(1 page 63)
47
GB