Parameter Level - PMA KS 90 Mode D'emploi

PARAMETER LEVEL

At parameter level, the instrument is matched to the process. Only the parameters
which are required for the configured instrument are displayed.
Parameter name
2nd set-point (ramp too)
2nd segment time (ramp too)
3rd set-point
3rd segment time
.
.
.
11th set-point
11th segment time
Correcting variable for start-up YA
Set-point for start-up
Holding time for start-up
Limit contact 1 low
Limit conta t 1 high
Limit conta t 2 low
Limit contact 2 high
Alarm switch. differential LC1 SdA1 1...9999 *
Alarm switch. differential LC2 SdA2 1...9999 *
Switch. differential signaller
Operation locking
Ü SP2 can be switched off ( D, display '----'). Ramp function and programmer are
off and parameters SP3... SP11 / Pt2... Pt11 are not displayed. With the
function (ramp or program) running, the relevant parameters can be adjusted.
* The displayed value depends on the decimal point.
Ö If LCL1 / LCH1 / LCL2 / LCH2 are switched off ( D, display '----'), the corre-
sponding parameter is not effective.
Locking the operation (parameter Loc)
In operating level
Loc is indicated:
0 X, W/ SP2, Y
1 X, W/ SP2, Y
2 X, W/ SP2, Y
3 X
1 In manual mode, the correcting variable Y is adjustable in the operating level.
2 With ramp function and SP2 reached, SP2 is also adjustable in the operating level.
10
Pressing keys I or D changes the value (the longer the faster).
The change is effective after 2 s or when pressing M shortly; M
is also used for switching to the next parameter.
+The parameter level is left after a time-out of 30 s or by
pressing key M shortly after the last parameter.
Symbol Adjustment range
SP2
Pt2
SP3
Pt3
.
.
.
SP11 SPL... SPH *
Pt11 0...9999 min
SPA
PtA
LCL1 relative: 1...9999 ; absolute: SPL...9999 *Ö
LCH1 relative: 1...9999 ; absolute: SPL...9999 *Ö
LCL2 relative: 1...9999 ; absolute: SPL...9999 *Ö
LCH2 relative: 1...9999 ; absolute: SPL...9999 *Ö
SdS
Loc
is adjustable 1:
W/ SP2, Y 2
W/ SP2, Y 2 not permitted
Y not permitted
Y (no display) not permitted
SPL... SPH Ü*
0...9999 min
SPL... SPH *
0...9999 min
.
.
.
5...100%
SPL... SPH *
0...9999 min
1...9999 *
0...3 (Ä locking the operation)
The self
+With Loc > 0, the following
tuning is
permitted
If a set-point is set to ----, the
following segments are omitted
parameters are not displayed
and cannot be changed.