Removing The Sling - arjo Sara 3000 Mode D'emploi

Masquer les pouces Voir aussi pour Sara 3000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47

Removing the Sling

In Chair/Wheelchair (11 steps)
1. Apply the brakes on the wheelchair.
2. Position the patient with the his/her back
against the chair/wheelchair. Open up the lift
legs on
(See Fig. 13 )
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
3. Lower the patient into the chair/wheelchair.
See
4. Make sure that the patient's lower back is
positioned all the way in against the chair/
A
patient is taken up by the receiving surface
before removing the clips/loops. (See Fig. 14 )
5. Apply the brakes on the
Flex lift.
Fig. 13
6. Detach the sling clips/loops from the
7. Transfer Sling only:
Detach the leg straps from the
, if needed.
Open and pull them out
from under the patient's legs.
Tuck the leg straps backwards
along the patient's side.
Remove the patient's feet from the foot
support.
9. Move the
from the patient.
.
10. Open the sling support belt.
11. Lean the patient forward and remove the sling
from behind the patient. (See Fig. 15 )
Fig. 14
A
11
. (See Fig. 7 )
EN
/Flex away
Fig. 15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sara liteSara stedySara flex active slings

Table des Matières