Publicité
Les langues disponibles
Les langues disponibles
ENG
Instruction Manual BIG THEO OUTDOOR
1.
Use as directed:
This product serves exclusively lighting purposes and may:
only be used with a voltage of 230V ~50Hz.
not be exposed to strong mechanical loads or to strong
contamination.
only be installed and operated after a condition inspection if the
product is dirty or has been moistened through storage.
not be modified or converted.
If these points named above are not adhered to, a short circuit or
electrical shock may occur!
2.
Technical Data:
229564
Operating voltage:
230V ~50Hz
Safety class:
I
Safety type:
IP 44
Bulb:
QPAR111,
GU10, max. 75W
Dimensions (W/H/D):
13/13,5/13 cm
Weight:
0,8 kg
Importeur:
SLV Elektronik GmbH
IP 44: Protection against foreign objects > Ø 1,0mm - Protection against
splashing water from all directions.
3.
Installation
The electric connection may be executed only by an electric expert
who is familiar with the valid directives!
Attention: Switch off the power of the mains supply line or
respectively of the connection lead before doing any works
parts, which are supplied with the product or are described as accessories!
Otherwise the product or the installation might not be sufficiently safe.
Installation place:
The product is suited for wall installation.
Make sure that the product is mounted on a stable, even and tilt-fixed
background.
The light exit should be placed at least so far from the illuminated surface,
as indicated as minimum distance on the type plate of the luminaire:
m
. Pay special caution to easily inflammable objects.
Separate Installation Steps
Unscrew the four screws of each side cover. Remove the side cover (1).
Take off the mounting plate by loosening the retaining pegs (2).
Determine the place of installation and mark the holes to be drilled. Note
that the cable outlet of the power supply line fits between the mounting
bracket and the canopy. Do not damage the power supply line, e.g. by
drilling, screws or strong bending.
Fasten the mounting plate to the mounting surface (3).
Electrical Connection
The product must be able to be separated by an all pole separation from
the current supply.
For electric connection attach the black or brown wire (live conductor) of
the mains supply with the clamp L and the blue wire (neutral conductor)
of the mains supply with the clamp N. The green-yellow wire (protective
conductor) of the mains supply has to be tightly screwed into the earth
clamp
of the product.
Now fasten the fixture back to the mounting plate.
Inserting the bulbs: Insert the bulbs with a quarter-turn to the right.
Reassemble the fixture in reverse order. Pay attention to the right fit of
all gaskets.
The product is now ready for operation.
4.
Operation
:
Information for the user:
Operate the product only if it is working correctly. Switch off the product
with a malfunction immediately and operate it again only after examination
by an electrical specialist. This is the case, when:
visible damages appear.
the product does not work.
smoke, steam or crackling sounds appear.
an overheating is recognisable.
Repairs of the product or work on mains voltage-prominent sections may
only be carried out by qualified electricians.
Attention: Here exists mortal danger from an electric shock!
229574
230V ~50Hz
I
IP 44
2x QPAR111,
GU10, max. 75W
13/27/13 cm
1
1,65 kg
.
Use only
0,8
How to avoid failure and fire risk:
Do not cover the product - provide free air circulation!
Do not hang or fasten anything on the product, especially no
decoration.
Never let children play unsupervised with electric products! Children
can not always estimate dangers in dealing with electric energy correctly.
2
L
N
3
What is to do if a bulb is defect or does not work?
Disconnect the product from power, before you exchange
the bulbs.
Caution: Let the bulb cool down first before replacement –
otherwise considerable risk of injury exists because of the hot
surface.
Replace the bulbs only with bulbs of the same data like socket,
power and capacity. Every other sort of bulb can lead to
damages of the light.
Replacing the bulb: see Installation.
5.
What else has to be considered?
Disconnect the product from power, before you...
clean or maintain the product.
do any works on the product or its components (electric expert).
09/2005 by SLV Elektronik GmbH
229564/74A
Technical Details are subject to change.
Duplication prohibited !
F
Mode d'emploi BIG THEO OUTDOOR
1.
A utiliser comme indiqué :
Ce produit ne sert qu'à éclairer:
il est prévu pour une tension de 230V ~50Hz.
il ne doit être soumis ni aux efforts mécaniques importants ni à un
encrassement important.
il ne doit être utilisé qu'après examen si le produit a été stocké dans un
entrepôt humide ou sale.
ne doit pas être modifié.
Un non-respect de ces points peut causer un court-circuit ou une
décharge électrique!
2.
Informations techniques:
229564
Tension d'alimentation:
230V ~50Hz
Classe de protection:
I
Degré de protection:
IP 44
Ampoule:
QPAR111,
GU10, max. 75W
Dimensions (L/H/P):
13/13,5/13 cm
Poids:
0,8 kg
Importeur:
SLV Elektronik GmbH
IP 44: Protection contre les corps étrangers durs > Ø 1,0 mm - Protection
contre les éclaboussures provenant de toutes les direction.
3.
Installation
La connection électrique doit être exécutée par un professionnel,
lequel est familier des normes en vigueur!
Attention: Mettez l'alimentation électrique ou le raccordement au
secteur hors tension avant de travailler!
Utilisez seulement des pièces qui ont été livrées avec le produit ou qui sont
uniquement décrites comme accessoires ! Sinon, l'installation ainsi que le
produit ne peuvent pas être garantis.
Lieu d'installation
Ce produit est fait pour un montage au plafond. Veillez à ce que le produit
soit monté de manière stable et résistante au basculement.
La distance entre la sortie de lumière et la face illuminée devrait au moins
être tant que la distance minimale indiquée sur l'étiquette du type du
0,8 m
lumière:
. Soyez prudent avec les matières inflammables.
Etapes successives pour installer le luminaire
229574
230V ~50Hz
I
IP 44
2x QPAR111,
GU10, max. 75W
13/27/13 cm
1,65 kg
Publicité
