Side Broom - TSM DURASWEEP 130 B Mode D'emploi

IMPORTANT: The width of the track must measure no less than 4 cm.
11.6

Side broom:

If you notice that the side broom no longer directs debris towards the central broom, it is necessary to adjust its height as
follows:
Holding the side broom in a raised position, unscrew the Allen key inside one of the adjusting holes Detail 2 Fig. 9 and
place it inside the lower hole.
11.7 Debris hopper:
Every 50/60 hours of operation, or whenever necessary, clean the debris hopper Detail 1 Fig. 6 and the 3 plastic
containers using hot water and possibly common detergent to avoid any bacterial growth (wear rubber gloves).
GENERAL RULE: For the correct and long-lasting operation of the machine, keep the exterior body clean, as well as the
interior, under the hood by blowing compressed air (this operation must be carried out with the motor off and cold).
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com
52
DURASWEEP 130 B
OPERATING MANUAL
V01