TSM DURASWEEP 130 B Mode D'emploi page 51

11.3 Dust gaskets:
Every 40/70 hours of operation, check the conditions of
the dust washers Detail 1 (mobile) and Detail 2 and 3
(3 fixed) Fig. 14 that surround the central broom,
changing them when necessary.
IMPORTANT: The height of the side flaps Detail 2
Fig. 14 can be adjusted by sliding them along the
slots. If they need to be replaced, once they have
been assembled, make sure that they are raised
approximately 2 mm from the ground.
11.4 Central brush:
Detail 2 Fig. 5. Every 50/80 hours of operation, or as
needed, make sure the central broom is in good
condition, especially if you suspect that cords, wires, etc
have been accidentally collected.
If it is necessary to remove these materials from the
broom, you must:
1. Remove the hopper Detail 1 Fig. 6.
2. Get down on all fours and look at the central broom underneath the machine; wearing gloves and a mask to protect
your respiratory tract, remove any cords or wires that are tangled around the central broom. It is also possible to use
the 3 hooks included (eyebolts) to lift the machine (see Fig. 1) and perform this operation being careful not to station
yourself under the machine.
11.5 Central brush:
If you notice that the machine no longer cleans
perfectly or leaves debris behind, you will need to
adjust it by lowering it as follows:
1. Place the lever illustrated in Fig. 10 in a position
where the central broom is raised.
2. Loosen the register screw Detail 1 Fig.
15.
3. Lower the register by 3/4 mm or the required
amount.
4. Lock the register by tightening the screw.
5. Place the lever illustrated in Fig. 10 above the
register Detail 1 Fig 15.
6. It is possible to adjust the central broom until the
register Detail 1 Fig. 15 reaches the end run; at
this point it is necessary to change the broom.
IMPORTANT: To make sure the central broom is adjusted correctly, it is necessary to measure its "Track", as
follows:
1. Once the adjustments have been made, start the machine and, without travelling forwards or in reverse, leave it on
the spot for at least 10/15 sec. with the central broom lowered.
2. Turn the motor off, raise the central broom and manually move the machine forwards, until you can see a track left by
the rotation of the central broom on the floor, as illustrated in Fig. 16.
A D J U S T M E
A D J U S T M E
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com
51
DURASWEEP 130 B
OPERATING MANUAL
N T S
N T S
V01