TSM DURASWEEP 130 B Mode D'emploi page 49

9 9 . . 4 4 N N e e u u t t r r a a l l : :
1 . Place the selector Detail 7 in the control panel (Fig. 11) in the central position for the machine will be in neutral
1 .
9 . 5 S t o p :
9 . 5 S t o p :
1. Release the drive pedal Detail 3 Fig. 7; you will notice that the machine tends to stop within a short distance, if you
wish to stop press the brake pedal abruptly Detail 1 Fig. 7.
10 CORRECT USE AND ADVICE
IMPORTANT: Before starting operation, check for cords, plastic or metal wires or long rags, sticks, power cords
etc on the surface; these are dangerous and could damage the dust washers and brooms. It is therefore
necessary to remove them before operating the machine.

Be very careful when driving over rails, or door guides etc. as they are the greatest source of damage to the dust
washers, as they must pass over them, it is necessary to drive very slowly.

Avoid driving over puddles.

When there are bulky or light objects to collect (leaves, cigarette packs, etc.) lift the front flap by pressing the flap-lift
pedal with your LT foot Detail 2 Fig. 7.

If the surface requiring cleaning is very dirty in terms of amount or type of material or dust to collect, it is advisable to
carry out an initial "rough" cleaning, without taking into account the final result, then, with the hopper emptied out and
the filters well-shaken, clean the surface again; accordingly, you will obtain the required result.

Following this procedure, by using the machine at regularly and at the right times, it will no longer be necessary to
carry out the "rough" cleaning procedure.

The side broom must only be used to clean edges, profiles, corners, etc. It must be lifted (disabled) immediately after
use to avoid raised unnecessary dust, and also because the results obtained with the side broom enabled is never as
good as operation with the central broom only.

For good results, empty out the hopper often and keep the filters clean by shaking them with relative tools.
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com
49
DURASWEEP 130 B
OPERATING MANUAL
V01