Gear Shift - TSM DURASWEEP 130 B Mode D'emploi

IT IS ADVISABLE NOT TO WAIT FOR THE RED LED TO COME ON TO RECHARGE THE BATTERIES,
BUT TO CHARGE THE BATTERIES WHEN THE INITIAL YELLOW LED COMES ON.
5.17 Hour meter:
Detail 5 An instrument that displays the number of hours of work carried out by the machine.
5.18 Ignition key:
Detail 6 This switches on the entire control panel, especially the potentiometer, for driving; it is possible to drive without
working.
5.19

Gear shift:

Detail 7 The gear selector lever is used to make the machine travel forwards or in reverse. When the selector is in the
forward drive position (in the direction of the forwards arrow). By pressing the pedal Detail 3 Fig. 7 the machine will
travel forwards. Vice versa, when the selector lever is in the back position, by pressing the pedal the machine will travel
in reverse. For safety reasons, the speed of the machine in reverse drive is much slower. By leaving the selector in
the central position, the machine will not go into forward or reverse drive.
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com
45
DURASWEEP 130 B
OPERATING MANUAL
V01