Measuring - VOLTCRAFT LCR-300 Mode D'emploi

8. MEASuRINg

Do not exceed the maximum permitted input values. Do not touch any circuits or
parts of circuits if they may be subject to voltages higher than 33 V ACrms or 70 V
DC! Danger to life!
Before measuring, check the connected measuring lines for damage such as, for
example, cuts, cracks or squeezing. Defective measuring lines must no longer be
used!
During measuring, do not grip beyond the tangible grip range markings present on
the measuring prods.
Measuring is only permitted when the housing and battery compartment is closed.
Only the two measuring lines that are required for measuring operation must be
connected to the meter at any time. Remove all measuring lines not required from the
meter for safety reasons.
If „OL" (overload) appears on the display, you have exceeded the measuring range.
Perform calibration before any measuring series to warrant accuracy. Calibration is described in
detail in chapter 7.7. Calibration.
45