Control Elements - VOLTCRAFT LCR-300 Mode D'emploi

5. CONTROL ELEMENTS

See fold-out page
1 Display (LCD)
2 Operating button
3 FUNC. button: Switching button for measuring functions
4 CAL button: To perform device calibration for precise measured values
5 Rear battery compartment and folding setup bracket
6 SORTING button: For quick sorting measurements for tolerance determinations
7 Arrow up
8 HOLD button to "freeze" the displayed value
9 D/Q/ESR button: Switching display parameters in L/C measuring operation, arrow to the left
10 SETUP button: To set the reference and tolerance parameters in sorting mode
11 SER/PAL button: To toggle serial and parallel mode, arrow to the right
12 FREQ button: To switch the measuring frequency
13 REL% button: To display the relative deviation in % from a reference value; arrow down
14 Light button to activate and deactivate the display lighting
15 ENTER button: To confirm the input in sorting mode
16 Lateral mains adapter socket
17 Connection and measuring sockets
18 Calibration plug "SHORT" for zero calibration
19 Four-conductor measuring terminals with shield (Kelvin measuring lines)
35