Symbols On The Product; Product Information; Declaration Of Conformity; General Power Tool Safety Warnings - Hilti AG 500-7SE Mode D'emploi

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Wear eye protection.
Revolutions per minute
Revolutions per minute
Rated speed
Diameter
Protection class II (double-insulated)

1.4 Product information

Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment may present hazards when used incor-
rectly by untrained personnel or when used not as directed.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to enquire about the product.
Product information
Angle grinder
Generation
Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
declaration issued by the certification department can be found at the end
of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916
Kaufering, Germany
2 Safety

2.1 General power tool safety warnings

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
2 English
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02
AG 500-7SE
05
A copy of the