Care And Maintenance - Hilti AG 500-7SE Mode D'emploi

7 Care and maintenance

7.1 Care and maintenance
WARNING
Danger of electric shock! Carrying out care and maintenance while the
supply cord is connected to the power outlet presents a risk of serious
injuries including burns.
▶ Always unplug the supply cord before carrying out all care and
maintenance tasks.
Care
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as they can attack the plastic parts.
Maintenance
• At regular intervals, check all visible parts and the controls for signs of
damage and make sure that they all function correctly.
• Do not operate the power tool if signs of damage are found or if parts
malfunction. Have damage repaired immediately by Hilti Service.
• After cleaning and maintenance, refit all guards or protective devices and
check that they function correctly.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare
parts and consumables. Spare parts, consumables and accessories
approved by Hilti for use with the product can be found at your local
Hilti Store or online at: www.hilti.group / www.hilti.com
7.2 Replacing the supply cord
7.2.1 Removing the supply cord
1. Disconnect the supply cord plug from the power outlet.
2. Unscrew the screw in the rear part of the housing and remove the rear
part of the housing.
3. Slacken the two strain relief clamp screws.
4. Unscrew the two screws and disconnect and remove the supply cord.
7.2.2 Fitting the supply cord
1. Work the supply cord into position in the rear part of the housing.
2. Push the supply cord through the protective sleeve.
3. Strip 5 mm of insulation off the ends of the conductors.
4. Insert both conductors under the strain relief clamp.
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02
11
12
English 17