Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8 Transport and storage
• Do not transport electric tools with accessory tools fitted.
• Always unplug the supply cord before storing an electric tool or appliance.
• Store tools and appliances in a dry place where they cannot be accessed
by children or unauthorized persons.
• Check electric tools or appliances for damage after long periods of
transport or storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, contact Hilti Service.
Trouble or fault
The tool doesn't
start.
The tool doesn't
work.
The tool does not
achieve full power.
10 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Disposal of electric tools or appliances together with household
waste is not permissible.
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02
Possible cause
Interruption in the elec-
tric supply.
The supply cord or plug
is defective.
The carbon brushes are
worn.
The tool has been over-
loaded.
The extension cord con-
ductor cross section
(gauge) is inadequate.
Action to be taken
▶ Plug in another power
tool or appliance
and check whether it
works.
▶ Remove the supply
cord. → page 17
▶ Fit the supply cord.
→ page 17
▶ Replace the carbon
brushes. → page 18
▶ Release the on/off
switch and then press
it again. Then allow
the power tool to run
under no load for
approx. 30 seconds.
▶ Use an extension cord
with an adequate con-
ductor cross section.
English
19
Publicité
Table des Matières
