Hilti AG 500-7SE Mode D'emploi page 21

6 Operation
6.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool
or before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
6.2 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.3 Guard
▶ Observe the instructions for fitting the applicable guard.
6.3.1 Fitting the guard
Note
The keying on the guard ensures that only a guard designed for use
with the power tool can be fitted. The keyed locating lug also prevents
the guard from coming into contact with the disc.
1. Release the clamping lever.
2. Fit the guard onto the spindle collar so that the keyed locating lug engages
in the recess provided.
3. Rotate the guard to the required position.
4. Secure the guard by closing the clamping lever.
Note
The guard is already set to the correct tension by way of the adjusting
screw. If the tension is too low when the guard is fitted, the adjusting
screw can be tightened slightly to increase the tension.
6.3.2 Adjusting the guard
1. Release the clamping lever.
2. Turn the guard to the required position.
3. Secure the guard by closing the clamping lever.
6.3.3 Removing the guard
1. Release the clamping lever.
2. Rotate the guard until the keyed locating lug is aligned with the keyed
locating groove and then remove the guard.
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02
5
6
English 13