Hilti AG 500-7SE Mode D'emploi page 24

6.8 Types of work
WARNING
Damaged power cords are a safety hazard! If the supply cord or
extension cord is damaged while work is in progress, immediately
disconnect the device and the cord from the electricity supply. Do not
touch the damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords.
Have damaged power cords replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a
maximum tripping current of 30 mA is recommended.
6.9 Switching on
1. Plug the supply cord into the power outlet.
2. Press the rear section of the on/off switch.
3. Slide the on/off switch forward.
4. Lock the on/off switch.
◁ The motor runs.
6.10 Cutting
▶ When cutting, apply moderate feed pressure and do not tilt the power
tool or the cutting disc (when working, hold at approx. 90° to the surface
being cut).
Note
For best results when cutting profiles and square tube, start cutting
at the smallest cross section.
6.11 Rough grinding
CAUTION
Risk of injury. The abrasive cutting disc could shatter and flying
fragments may cause injury.
▶ Never use abrasive cutting discs for grinding.
▶ Move the power tool to and fro while maintaining a 5° to 30° angle of
attack and applying moderate pressure.
◁ This will avoid overheating and discoloration of the workpiece and help
ensure an even surface finish.
6.12 Switching off
▶ Press the rear section of the on/off switch.
◁ The on/off switch jumps into the off position and the motor stops.
16 English
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02