Hilti AG 500-7SE Mode D'emploi page 20

Item Equipment
E Side handle
F Clamping nut
(not for use with
accessories
with integrated
thread)
G Clamping flange
(not for use with
accessories
with integrated
thread)
H Clamping nut
for abrasive
resin-fiber disc
I Support plate
5 Angle grinder
Note
For rated voltage, frequency, current and input power, please refer to
the country-specific type identification plate.
If the device is powered by a generator or transformer, the generator or
transformer's power output must be at least twice the rated input power
shown on the type identification plate of the device. The operating voltage
of the transformer or generator must always be within +5% and -15% of the
rated voltage of the device.
Rated power input
Rated speed
Maximum disc diameter
Maximum disc diameter
Drive spindle thread
Weight
12 English
Printed: 12.09.2017 | Doc-Nr: PUB / 5373357 / 000 / 02
AC­D AG­D, DG-
AF­D,
AN­D (SPX,
SP, P)
X X
X X
X X
— —
— —
DC- AP-D
CW TP,
DC-D
(SPX,
SP, P)
X X
X X
X X
— —
— —
AG 500-7SE
780 W
11,500 /min
125 mm
5 in
5/8"-11
4.4 lb
(2.0 kg)
3CS,
4CS,
3SS,
4SS
X X
— —
— —
X —
X —