Jay J3 Back - Sunrise Medical QUICKIE Sedeo Pro Advanced Manuel D'utilisation

4.7.3 JAY J3 Back

Mounting and adjusting the JAY J3 should be done without
the user in the power chair.
Remove the foam and cover from the back shell until the
mounting and adjustments are complete. Once complete,
replace foam and cover to the shell assembly.
After finishing the JAY J3 installation, the user can be seated
back in the wheelchair.
Height Adjustment (Fig. 4.25)
1. Using 5mm hex key, loosen four M6 screws (D).
2. Slide shell assembly (E) up or down to desired height.
3. Re-tighten the screws.
NOTE: The JAY J3 Backrest can be used in conjunction with
the Sedeo Pro Advanced seating system. Please refer to the J3
Back Owner's Manual for fitting and adjustment.
Sedeo Pro Advanced/Advanced UP Rev.A
E
D
Fig. 4.25
17