Tilt-In-Space Mechanism; M.height-Adjustable Back With Adjustable Stroller Handle - Sunrise Medical Quickie Iris Manuel D'utilisation Et Garantie

26
L. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger mechanisms positive-
ly lock the chair in place from -5º to 60º depending on the set-up. The Quickie IRIS has
the capability to provide from 0º to 5º of forward tilt. DO NOT ATTEMPT TO MAKE THIS
ADJUSTMENT. This adjustment must be done by an authorized supplier.
1. Tilt Operation
a. Depressing both triggers (C) at the same time disengages the locking mechanism and
allows the seat and back to rotate in space. Releasing the triggers positively locks the
rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (D).
c. To lock out the tilting function, insert the locking pin (E) into the trigger holder.
2. Tilt-stops Adjustment
Adjustments can be made to limit the amount of tilt (rotation) that the chair provides by
using the tilt-stops (A).
a. Loosen and remove the retaining screw (B).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes on the rocker
(C), then secure in place by tightening the screw (B).
3. Cable Adjustment
NOTE– Do not use lubricants on the components or assembly.
a. Loosen and remove nuts (D) and remove bracket assembly (E).
b. Loosen the jam nut (F).
c. Rotate the cable adjuster (G) until slack
is removed from the cable. Make sure the plunger pin can fully extend and retract
after adjustment.
d. Tighten jam nut (F).
e. Reinstall the bracket assembly (E).
f. Install and tighten nuts (D).
M. HEIGHT-ADJUSTABLE BACK WITH ADJUSTABLE STROLLER HANDLE
(OPTIONAL)
1. Angle Adjustment
a. Loosen rear bolt (F).
b. Loosen and remove front bolt (G).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt (G).
e. Tighten rear bolt (F).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 240 in.-lbs. When setting-up the angle adjustment of the stroller handle.
2. Angle Adjustment of the Stroller Handle
Depress both black push buttons (H) at the same time. This disengages the stroller handle
and allows it to rotate freely. Releasing the push buttons positively locks the adjustable
stroller handle in the desired position.
3. Height Adjustment
a. Remove both bolts (I) from the backrest tube (one on each side).
b. Reposition backrest height.
c. Re-tighten both bolts (I) in the desired location.
931135 Rev. A
E n g l i s h
I X . S e t - U p & A d j u s t m e n t
C
D
C
A
B
F
G
G
I
H
E
F