ProMinent DULCOTEST CLT 1 Mode D'emploi page 35

IMPORTANT
For electrical connection of the sensor to the controller, only use wires
with a diameter of 4 mm (see Order information, Chapter 15)
Electrical
installation
Fig. 4
Electrical
connection of
the sensor
®
ProMinent
Turn the top part of the sensor a quarter of a turn anticlockwise and
remove.
Remove the outer isolation of the cable for about 5 cm from the end so
that the two wires appear.
Loosen the M12 threaded connector and guide the 2-wire cable into the
sensor, providing a surplus length of 5 cm inside the sensor.
Strip the two wires at their ends and connect them to the terminal block by
using the screwdriver provided: 1 = plus, 2 = minus (see figure 4).
Tighten up the M12 connector.
Insert the top part of the sensor right into the housing and turn the top part
clockwise as far as it will go.
Installation
35