Ac Power Connection - SOUNDMASTER UR220 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
UR220 / English Manual

AC POWER CONNECTION

Plug the AC power cord into a household outlet AC source.
SETTING THE CALENDAR AND TIME
1. In standby mode, press and hold the unit button (7) or the remote control
button (12) for about 2 seconds to enter the calendar/time set mode.
2. The year indicator will flash on the LED DISPLAY for up to 30 seconds
prompting for a new entry.
3. While the display is flashing, repeatedly tap the unit buttons (10), (11) or the
remote control button (7), (11) to adjust to the correct year. Press and hold the
unit (10), (11) button or the remote control button (7), (11) for faster scanning
backward or forward. Tap the unit button (7) or the remote control button (12) to
confirm.
4. Repeat steps #2 to #3 to adjust the month, day, time format, current hour and
finally current minute in the same way.
Notes:
-The display sequence in calendar / time set mode will be as follows:
Year → Month → Date → 12/24 Hour Time Format → Real Time Hour →
Real Time Min → Normal Time
-To check the year while current time is displayed, tap the unit button (10) or the
remote control button (13) once. The LED DISPLAY will change to year display
for 5 seconds and then revert to current time automatically.
-To check the date while current time is displayed, tap the unit button (10) or the
remote control button (13) twice. The LED DISPLAY will change to date display
for 5 seconds and then revert to current time automatically.
-During the time set, if no button is being pressed within 10 seconds, the current
display time will be automatically stored.
-Make sure the hour is set so that the PM indicator is displayed correctly for
afternoon/night times.
Switching the Unit On/Off
Press the unit on/off button (14) or the remote control on/off button (1) to switch
the unit on or off.
Volume Adjust
Press the unit (12) and (13) button or the remote control button (9) and (14)
button to set the desired volume level. The volume level reading will appear in
the LED DISPLAY.

Publicité

Table des Matières
loading

Table des Matières