Remote Control - SOUNDMASTER UR220 Mode D'emploi

UR220 / English Manual

REMOTE CONTROL

The remote control works on one 3V "CR2025 type" lithium battery (included). To
active the remote control, remove the insulation tab inserted in the battery
compartment. To remove the tab, pull it in the direction of the arrow as shown in
the illustration.
If the operation of the remote control becomes unsatisfactory, replace the original
battery with a new 3-volt lithium battery of the same type.
1. Slide out the battery holder from the remote control case. (see diagram).
2. Replace the weak/dead battery with a new one. Be sure the battery is
installed correctly. The remote control will not work if the battery is
installed with wrong polarity,
CAUTION: Danger of explosion if the battery is replaced incorrectly.
Replace only with the same or equivalent type of battery.
3. Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the longest life and
best performance.