SOUNDMASTER UR220 Mode D'emploi page 27

UR220 / English Manual
NOTE:
• The alarm function turns off automatically after 30 minutes until the next day.
7a. If you want to be awakened by a radio station, select the maximum alarm
volume using the unit (10) and (11) buttons or the remote control (7) and (11)
buttons.
8. Press the unit Alarm 1 button (12) or the remote control Alarm 1 button (8) to
confirm. Then select the light intensity (L ) for the alarm function. Selecting
"OFF " will cancel this function.
NOTE:
The light inside the lamp shade (1) will turn on 30 minutes prior to the pre-set
alarm time. The brightness will gradually increase, starting at the intensity level
previously set.
9. Finally, press the button again. The first alarm time is now activated.
To set the second alarm time, repeat the above steps with the main unit Alarm 2
button (13) or the remote control Alarm 2 button (10).
NOTE:
• If the alarm time has been activated, AL1 or AL2 will appear in the display.
• In order to briefly display the set alarm times, press the unit Alarm 1 button (12)
or the remote control Alarm 1 button (8) , respectively the unit Alarm 2 button (13)
or the remote control Alarm 2 button (10).
Turning off the Alarm Press the unit on/off button (14) or the remote control on/off
button (1) to stop the alarm.
Deactivate the Alarm Function
1. Switch the device to standby with the unit button (14) or the remote control
button (1).
2. To deactivate the alarm function, press and hold the main unit button (12) and
(13) or the remote control button (8) and (10) for about 3 seconds . AL1 or AL2
will disappear.
SNOOZE FUNCTION (MAIN UNIT)
When the alarm source is sounding, press the unit any buttons (except on/off
button (14)) or the remote control SNOOZE button(3) to suspend the alarm and
activate the snooze function. The Alarm will temporarily stop and sound again 9
minutes later but the AL1 (or AL2) indicator will keep flashing.
Notes:
This manual snooze operation can be repeated again and again.
To turn off the snooze function, Press the main unit on/off button(14) or the
remote control on/off button (1). The AL1 (or AL2) INDICATOR will stop flashing