SOUNDMASTER UR220 Mode D'emploi page 24

UR220 / English Manual
AUTOMATIC SEARCH FOR RADIO STATIONS
To automatically search for stations with strong signals, press and hold the main
unit button (10) and (11) or the remote control button (7) and (11) until the
frequency readout on the display begins to scan. Release the button. The tuner
will stop on the first strong station it finds.
MANUAL SEARCH FOR RADIO STATIONS
1. Tap the unit (10) and (11) button or the remote control button (7) and (11)
repeatedly to choose your desired radio station.
2. Tap the unit (12) and (13) button or the remote control button (9) and (14) to
set the desired volume level. The volume level reading will appear in the LED
DISPLAY.
Notes:
- Use manual tuning to select weaker stations that might be skipped during
automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning
method to "fine tune" to the exact frequency of the desired station.
HINTS FOR BEST RECEPTION
FM - To insure maximum FM tuner reception, unwrap and fully extend the
EXTERNAL FM WIRE ANTENNA for best FM radio reception.
TO SET/RECALL RADIO STATION PRESETS
1. Press the unit button (10) and (11) or the remote control button (7) and (11)
select the desired radio station.
2. Press and hold the unit (7) button or the remote control button (12), the next
available preset memory number will flash on the LED display. (Note: "P01" will
flash in the display if you are programming presets for the first time.)
3. Press the unit button (10) and (11) or the remote control button (7) and (11) to
change to the desired preset number P01 thru P10.
4. Repeat steps #1 thru #3 to preset up to10 FM stations.
5. To recall one of the preset stations already programmed, Press the unit
button (7) or the remote control button (12) repeatedly until you reach the desired
preset number/radio station.