Connect To Power - SOUNDMASTER FUR5005 Manuel D'instructions

1. Once power connected, Indicator "FM" lighten, the radio will automatically scan the
radio station and store them that had been scanned until scan up all the frequency
or stored all the memory station.
2. After that, Indicator of "Update" will flashing, at the moment, device setting up clock
automatic and it may need 3-5 minutes or even longer when only insufficient FM-
RDS signal is available.
3. Once the setup done, the display will show real clock.
Note:
When it isn't possible to synchronize the clock automatically, pls. set the unit to a place with
better reception or set the clock manually (Setup device for advance).
Listen radio
• Press right rotary knob "
Tune left rotary knob "Tuning" (1) to adjust frequency by each 0.1MHz.
•
Tune left rotary knob "Tuning" (1), then pressing it will scan next or previous valid
•
station.
• Press and hold "Mem. Set" (1), then turn it to a desired memory position, press
"Mem. Set" (1) to confirm the storing.
Press "Preset/A.M.S." (6), then turn "Tuning" (1) to choose from the station list and
•
listen it.
Press and hold "Preset/A.M.S."(6) to activate the AMS (automatical memory storage)
•
function, it will scan up all the frequency and store the found stations to the preset
memories.
Turn right rotary knob "Volume" (2) to increase or decrease the volume.
•

CONNECT TO POWER

QUICK START GUIDE
" (2) once to turn on radio.
2
FUR5005 / English Instruction Manual