Dimmer Control - SOUNDMASTER FUR4005 Mode D'emploi

NAP timer function (count down timer)
During radio off mode, press the NAP button (1), to turn on the NAP mode, the NAP time will
keep by 5 seconds, within 5 seconds and press NAP button (1) button can change the duration
from 90 min – 10 min.
The alarm buzzer will sound for 30 min and then shut off automatically. To stop the alarm
buzzer, press the ON/OFF button (9).
Press the NAP button (1) has no effect during alarm operation. Press ON/OFF button (9) to
cancel NAP function.

DIMMER CONTROL

In standby mode,press the SNOOZE/SLEEP/DIMMER (8) button allows you to set the
brightness of the LCD display to high, medium and low 3 levels.
SPECIFICATIONS
Frequency range : 87.5 – 108 MHz
Battery backup : 3V (CR2032 Flat Lithium battery x 1) not included
Power supply : AC230V 50Hz
RESETTING
If the system does not respond or exhibits erratic or intermittent operation, you may have
experienced an electrostatic discharge (ESD) or a power surge that triggered the internal
microcontroller to shut down automatically. If this occurs, simply disconnect the ac power cord
and remove the system backup battery, wait for at least 3 minutes and then setup the unit again
as if it is a brand new unit.
1. No naked flame sources, such as lighted candles, should be placed on the apparatus.
2. Do not place the product in closed bookcases or racks without proper ventilation.
3. Where the mains plug is used as the disconnect device, the disconnect device shall remain
readily operable.
4. The ventilation should not be impeded by covering the ventilation openings with items, such
as newspapers, table-cloths, curtains, etc.
5. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
6. Do not connect FM antenna to outside antenna.
7. The unit should not be exposed to direct sunlight, very high or low temperature, moisture,
vibrations or placed in dusty environment.
8. Do not use abrasive, benzene, thinner or other solvents to clean the surface of the unit. To
clean, wipe it will mild non-abrasive detergent solution and clean soft cloth.
9. Never attempt to insert wires, pins or other such objects into the vents or opening of the unit.
10. Disconnect device warning : Main plug is used as the connection, so it should always remain
ready operate.
11. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
5
Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type
FUR4005 / English Instruction Manual
WARNING
CAUTION