Displaying Individual Stored Values - boso Medicus PC2 Mode D'emploi

Displaying individual stored values

You can recall stored readings by switching
on the unit and pressing and holding down
the START/STOP but-on until the last mea-
surement that has been stored appears in
the display (symbol
➡ Now all the stored measurement rea-
dings are shown successively for three
seconds. (If no measurements are sto-
red in memory, the systolic, diastolic
and pulse readings all show the value
'0' for three seconds.)
➡ By pressing the START/STOP button
again, the memory display is interrup-
ted and a new measurement started.
60
M
).
Clearing the memory
➡ Press the SET button for approximate-
ly five seconds until the
starts to flash.
The memory is now clear.
Changing batteries when the
monitor is switched on can result in
loss of data (see page 47. Change
batteries only when the monitor is swit-
ched off).
M
symbol