Flex LW 1503 Notice D'utilisation page 11

LW 1503
4. When the "RESET" button is
pressed again, it must be possible to
switch on the power tool.
DANGER
If the GFCI switch repeatedly switches
off when the machine is switched on or
if the GFCI switch does not trip,
immediately disconnect the machine
from the power supply.
Do not continue using the machine.
Have the GFCI switch replaced by
customer service only.
CONNECTING THE WATER
DANGER
Keep water away from the electric
power tool and from people within the
operating range. Do not switch on
power tools which have not been
connected correctly to the water
supply. Regularly check that seals,
shut-off valve and connectors function
correctly.
This tool is designed to be used in a wet
application.
4
1. Connect water supply hose to fitting
shown at (H) Fig. 4 and open water
supply valve. Never use the tool
without water flow.
5
2. The volume of water can be
regulated by adjusting shut-off valve
(V) Fig. 5.
6
Water will flow through spindle port (F)
Fig. 6.
NOTE
Keep water flow to a minimum for the
operation and direct water flow away
from the tool and operator. DO NOT
use tool in a dry grinding or sanding
application. Doing so will generate heat
sufficient to damage the seals of the
water feed system.
Instruction manual
11