Other Safety Instructions - Güde HPC 210 M Mode D'emploi Original

Masquer les pouces Voir aussi pour HPC 210 M:
Table des Matières

Publicité

was determined for. The apparatus correctly used
will perform the work more efficiently and better.
Never use the electric power or engine fuels driven
apparatus if he has not switch with on/off positions.
The apparatus working without this switch is
dangerous and shall be repaired.
Keep off the children even if the apparatus is
switched off. The persons not acquainted with the
apparatus or those ho have not read this
instructions are not allowed to operate the
apparatus, because the apparatuses driven by
electric power or engine fuel are dangerous when
manipulated by uninstructed users.
The apparatus shall never be operated
under following circumstances:
Perceptible fluctuation of engine revolutions
Perceptible fall of pressure
Faulty ignition
Occurrence of smoke or fire, work in closed rooms
Excessive vibrations
Rain or bad weather conditions
Dirty apparatus. Keep apparatus clean and clear
from oil, impurities and other foreign matters.
Do not aim the water flow at electric components or
on the apparatus itself.
Hold/aim the protection against spraying away
always with both hands
The hose shall never touch hot exhaust
Never touch the jet or water jet during the
operation.
Never refuel if the engine is working or is still hot or
if there is open fire nearby. Do not smoke near the
apparatus.
Check the jets and hoses before putting the
apparatus into operation.
The gun handle shall not be gripped during the
operation
High-pressure hose shall not have any breaks,
kinking or reductions when being laid
All hose supply pipe shall be properly connected
When putting the apparatus in operation in cold
weather the measures should be taken preventing
ice creation in the equipment
If the apparatus is not used the safety pin shall be
activated to prevent the unwanted release of water
jet under high pressure (see operation manual)
Trigger of the gun working under high pressure
shall not remain without handling for more than 5
minutes, otherwise the pump may be damaged.
Check in regular intervals possible untightness in
fuel system or signs of wearing as e.g. rubbing or
wet line or missing clamps, damaged tank or
(missing) cover. The failures like this shall be
unconditionally removed before putting the
apparatus into motion
Do not touch hot exhaust
The apparatus shall be operated,
maintained and the refuelled only under
following conditions:
Sufficient ventilation
Refuel only at sufficient lighting
Make sure the fuel does not spray away and never
refuel when the engine is on
During refuelling no ignition source may be nearby
Use lead-free petrol
Never work with damaged high-pressure hose
General Safety Instructions for High-Pressure
Cleaning Fuel Driven Apparatuses
Caution
: This apparatus is determined for work with
cleaning means offered and recommended by the
Manufacturer. The use of other cleaning means or chemicals
may reduce the safety of the apparatus.
Caution: Never operate the apparatus near other persons,
unless they wear protective clothing.
Caution: High-pressure jet may be very dangerous if used
incorrectly. Therefore the jet shall never aim at persons,
electric components or at the apparatus itself. Never aim the
jet at yourself or at other persons to clean the shoes or
clothing.
The safety of the apparatus is guaranteed only under
condition that original Manufacturer's spare parts or spare
parts recommended by the Manufacturer are used.
Caution: Hoses, connections, supply connections under high-
pressure are most important for the apparatus. Therefore only
supply connections and connections recommended by the
Manufacturer shall be used.
The apparatus shall not be used further in case the supply
connection or other important parts are damaged, as e.g.
safety jigs, high-pressure hoses or spray gun.
Caution: Use always proper type of petrol, other fuels may be
dangerous.
Caution: The apparatuses with combustion engines shall not
be used in closed spaces, unless the authorized testing
authority permits the equipment with sufficient ventilation.
Caution: Exhaust gases shall not be released in the
surrounding of ventilating equipments.
Safety Instructions Fuel
Caution: When handling fuels be always extraordinary
careful, because they can easily ignite and the vapours
are explosive! The below mentioned safety instructions
shall always be observed:
Use only properly checked tank/canister.
If the engine runs, do not remove the tank cover
and to not pump refuel the apparatus. The exhaust
of the apparatus must be sufficiently cold before
refuelling.
Do not smoke during refuelling
Never refuel the tank of the apparatus in the closed
spaces.
The apparatus or petrol canister shall never be
stored in closed spaces or in the regions with open
fire, as e.g. not far of the water heater.
If some petrol sprays out, the apparatus shall not
be started, it shall be placed in another place in
sufficiently safe distance.
The tank cover shall be always put on its place and
properly closed after refuelling.
The tank content may be discharged only in free
space.

Other Safety Instructions

Safety Valve with Heat Effect
The apparatus is equipped with a safety valve with heat effect
protecting the pump against overloading if the spray gun does
not work for a longer period of time or when a jet is clogged.
This safety system prevents overheating of the pump.
Set the apparatus always on „AUS/OFF", if you do not use it
for more than 5 minutes. Hereby you will prevent wearing of
the apparatus, reduce fuel consumption and extend the
service life of the pump that will not be overheated so much.
Safety Locking of Spray Gun.
The safety locking (Fig.1, Part 5) of the spray gun shall be
activated to prevent unwanted release of high-pressure water
jet if the apparatus does not work. (See Operation Manual)
Disconnecting Device at Low Oil Level
This apparatus is furnished with a device that will switch off
the apparatus when the oil level is low. If the oil level drops
under corresponding mark, the apparatus will be
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

86021

Table des Matières