Sinmag Europe IPSO Mode D'emploi page 19

4.3. How to set the pressure for the pusher:
1. Open the back cover and electric box, you will see the PC board, see following:
2. Press the button 1 and 2 at the same time, and you will see the PC board shows as following
photo.
3. Press the button 1 to choose the pressure 1-4.
4. Press the button 2 to enter the parameter of the pressure.
5. Press button 1 to increase the pressure or button 2 to decrease the pressure.
6. After setting the pressure, wait for 3 seconds and the PC board will exit the pressure
adjusting screen.
7. After setting all the pressure, wait for 5 seconds and the screen will turn dark.
1 2
ENG
19