Sinmag Europe IPSO Mode D'emploi page 24

5. Replace the blades of the front frame.
ENG
1. Loosen the FIRST LEFT 4 hexagonal socket head screws which tighten the blades.
2. Replace the blades and check that they are well positioned in the rocker arm pin.
3. Re-tension the blades by tightening screw, in order that the blades remain in the frame as a
mark of tension.
4. Then loosen the FIRST RIGHT 4 hexagonal socket head screws which tighten the blades.
5. Resume at step 2 and work your way to the center by alternating left and right side.
6. Resume the above steps for the rear frame.
NOTE: Place some kind of protection on the front frame blades to avoid any injury.
7. Re-assemble the frame to the machine body.
Make sure that the blades in the front and back frame are parallel when the upper sides of
the frames are on the same height.
8. Close the cover again, put the tablet in place again and fix it. Fix the bagging spade again.
24