GRAUPNER WILGA 2000 Guide Rapide page 37

1 X-408 computer RC system, 35 MHz band
1 Servo extension lead
Please refer to the main GRAUPNER FS catalogue for details of battery chargers.
Electric power system and accessories
1 LiPo flight battery
Materials and tools required
Cross-point screwdriver, e.g. Order No. 810, flat-nose pliers, steel ruler, scissors, e.g.
Order No. 26, balsa knife, e.g. Order No. 980, spray paint, e.g. Order No. 928.27.
Adhesives
UHU por, Order No. 959
UHU thread-lock fluid, Order No. 952
Paints
If you wish to paint the model, please bear in mind that you can only use paints which
are compatible with high-density foam, e.g. GRAUPNER styrofoam spray paint,
Order No. 928, or UNIVERSAL paint, Order No. 921. You can emulate the colour
scheme shown in the kit box illustration if you wish; alternatively you can use any
other scheme you like. The colours shown in the kit box illustration represent a scale
scheme.
Assembling the WILGA 2000
Please don't start building the model until you have studied the parts and the
instructions, and have a clear idea how all the parts fit together. If you are not
satisfied with any component, return it to your model shop before modifying it in any
way.
The fuselage
Insert the steel wire undercarriage unit in the recess in the fuselage, and fit the
retainer over it to prevent it slipping out.
The next step is to glue the fin to the fuselage and screw the tailplane in place, but it
is best to install the control surface horns first: position the horns and fit the retaining
screws through them and into the spreader plates. Tighten the screws just to the
point where the horns are firmly fixed to the control surfaces. You will find translucent
areas along the hinge pivot lines of the rudder and elevator. Place a steel ruler over
these areas and cut through them using a sharp balsa knife; the control surfaces will
then move more freely.
Fit the fin into the channel in the fuselage and slide it forward and down as far as it
will go.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
Order No. 4713 or 4713.B
Order No. 3935.11
Order No. 7631.3
37
04/2007