Step 11. Install Door And Drawer Panels - Monogram ZIK30GNNII Instructions D'installation

STEP 12 INSTALL DOOR AND DRAWER PANELS
1. Remove all door and drawer panel hardware and trim
from the refrigerator.
Item Quantity
Panel Brackets 12
Phillips Machine 34
Screws (for use
with SS Panel
Accessory)
Allen Hex Socket 12
Head Screws
Washers 12
Door Trim 6
Trim Caps 12
Allen Wrench 2
2. Attach A1 - F1 brackets to the door panels in the
locations identified below. Custom panels must have
pre-drilled holes as shown in Door Panel Templates:
31-1000149, 31-1000150, 31-1000151, 31-1000152.
If you purchased an SS Panel Accessory, use the
Phillips machine screws to attach the brackets to the
SS door panels. For custom panels, use an appropriate
wood screw.
D1 A1
Refrigerator
Panel
G1
G1
B1
E1
Freezer
F1
C1
Panel
A1
D1
Customizable
Panel
B1
E1
Back View of Panels
3. If you had custom handles made and they are not
currently attached to your panels, do so now.
4. Remove the screw caps from the adjustment pins on
the doors.
31-1000169 Rev. 1
Installation Instructions
Do not tighten the screws, you will
do that after assembly process
and left to right alignment.
5. Open the fresh food door to attach the fresh food
panel.
6. Rest the fresh food panel on the fresh food door by
aligning the hooks on the panel brackets with the
adjustment pins on the door.
7. Fasten the panel to the fresh food door in four locations
using the hardware shown below. Do not tighten the
screws. Screws will be tightened after panel alignment.
8. Shift the panel side to side to ensure even gaps with
the adjacent cabinetry on both sides.
9. Use an allen wrench
to adjust the fresh
food door panel depth
and height to align
with the adjacent
cabinetry. There must
be a minimum 1/8" gap
between the panel and
the adjacent cabinetry.
17
Align at top
and bottom
Screw and
Washer
Tighten one screw per bracket.
The other screws will be
tightened at the end of the
alignment process.
Depth Adjustment
Vertical
Adjustment