Installation Instructions; Tools Required; Materials Required - Monogram ZIK30GNNII Instructions D'installation

TOOLS REQUIRED

• Utility knife
• Stepladder
• Bucket
• Level
• Appliance hand truck
• Tubing cutter
• #2 Phillips screwdriver
• Drill and bit set
• Safety glasses
• Pliers
• Torx T-20, T-30 wrench
HARDWARE SUPPLIED
• Anti-tip bracket & screws
• Panel installation kit
• Door panel templates- Pub # 31-1000149, 31-1000150,
31-1000151, 31-1000152
• Water filter - Part # GSWF
• Drywall Anchors and screws
REFRIGERATOR/FREEZER LOCATION
Do not install the refrigerator/freezer where the
temperature will go below 55°F (13°C). It will not run
often enough to maintain proper temperatures.
Do not install the refrigerator/freezer where
temperatures will go above 100°F (37°C). It will not
perform properly.
Do not install the refrigerator/freezer in a location
exposed to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
31-1000169 Rev. 1

Installation Instructions

MATERIALS REQUIRED

Refrigerator Tubing kits
• Water shut-off valve
• Custom panels for fresh food door, freezer drawer and
Convertible drawer
• Velcro w/adhesive if using custom toekick.
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 1,200 lbs.
NOTE: Protect the finish of the flooring. Cut a large sec-
tion of the cardboard carton and place under the refriger-
ator where you are working.
11