Technical Data; Symbols; Intended Use; Power Supply And Start-Up - Festool EHL 65 E Guide D'utilisation

TO REDUCE THE RISK OF
INJURY, USER MUST READ INSTRUC-
TION MANUAL.

Technical data

Power
Speed (no load)
Plane width
Chip thickness
Max. rebate depth
Weight (excluding cable)
Degree of protection
1.1
Total Extension Cord
Lenght (feed)
Cord size (AWG)
720 W
15 600 rpm
65 mm (2.56'')
0 - 4 mm (0'' - 0.16'')
23 mm (0.90'')
2.4 kg (5.3 lbs)
1.2
25 50 100 150
18 16 12
V Volts
A Amperes
Hz Hertz
~ Alternating current
n No load speed
0
Class II Construction
rpm Revolutions or reciprocation per min-
ute
Ø Diameter
/ II
Warning of general danger
Read the Operating Instructions/
Notes!

Intended use

The tool together with the available Festool
accessories is designed for processing wood,
soft plastics and similar materials.
and injury resulting from incorrect usage!
Power supply
conform to the voltage indicated on the rat-
ing plate. A 16 A safety fuse (for 120 V) or
a corresponding protective circuit-breaker
is required.
To switch on, fi rst press the switch lock (1.2)
and then the switch (1.1) (press = ON, re-
lease = OFF).

Extension cable

If an extension cable is required, it must
have a sufficient cross-section so as to
prevent an excessive drop in voltage or
overheating. An excessive drop in voltage
10
reduces the output and can lead to failure of
the motor. The table beside shows you the
correct cable diameter as a function of the
cable length for the planer EHL 65 E. Use
only U.L. and CSA listed extension cables.
5

Symbols

The user is liable for damage
and start-up
The network voltage must