General Safety Instructions - Festool BMS 180 E Notice D'utilisation D'origine

Brush machine
RUSTOFI X BMS 180 E
1 Symbols
Warning of general danger
Electric shock
Read the operating instructions/notes
Wear ear protection!
Wear protective goggles!
Wear a dust mask!
Safety class II
2 Technical data
Power consumption
Rotational speed
dia.
Tool
Spindle thread
Dust extractor connection diameter
Protection class
Weight
3 Machine features
[1-1] On/off switch
[1-2] Switch-on lock
[1-3] LED
[1-4] Speed control
[1-5] Support roller
[1-6] Depth adjustment wheel
[1-7] Extractor connector
The specifi ed illustrations are at the beginning of
this operating manual.
4 Intended use
According to specifi cations, the machine is de-
signed to brush and texture wooden surfaces.
The user bears the responsibility for damage and
accidents caused by improper use.
5 Safety instructions

5.1 General safety instructions

WARNING! Read all safety warnings and
all instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Never allow children to use the machine.
5.2 Machine-related safety instructions
- This power tool is intended to function as a
wire brush. Read all safety warnings, instruc-
tions, illustrations and specifi cations provided
with this power tool. Failure to follow all in-
structions listed below may result in electric
shock, fi re and/or serious injury.
- Operations such as grinding, sanding, polish-
ing or cutting-off are not recommended to be
performed with this power tool. Operations
for which the power tool was not designed may
create a hazard and cause personal injury.
- Do not use accessories which are not specifi -
cally designed and recommended by Festool.
1500 W
Just because the accessory can be attached to
800 – 4000 rpm
your power tool, it does not assure safe opera-
150 mm tion.
M 14 - The rated speed of the accessory must be at
least equal to the maximum speed marked
27 mm
on the power tool. Accessories running faster
/ II
than their rated speed can break and fl y apart.
7.5 kg
- The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
- Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by fl anges, the arbour hole of the
accessory must fi t the locating diameter of
the fl ange. Accessories that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
- Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or acces-
sory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and
installing an accessory, position yourself and
bystanders away from the plane of the rotating
accessory and run the power tool at maximum
no-load speed for one minute. Damaged ac-
cessories will normally break apart during this
test time.
13