Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TP 220
GB
Original operating manual
1
Symbols
Symbol Significance
Warning of general danger
Read operating instructions and safety
notices!
Wear protective gloves.
Wear protective goggles.
Caution! Risk of cutting!
Do not dispose of as domestic waste.
Tip or advice
Handling instruction
2
Safety instructions
– Always attach the protective cover over the roll-
ers when the device is not in use. Risk of injury!
– Ensure that persons standing near the machine
are at a safe distance from the work area.
– Wear protective goggles and protective clothing.
– Do not touch the blade rollers. Risk of injury!
– When using solvent, always observe the safety in-
structions provided by the manufacturer.
– Make sure that the area where you are using the
solvent is well ventilated.
3
Intended use
The device is designed to perforate wallpaper. The
device makes holes and tears in wallpaper so that
water containing wallpaper stripper can penetrate
more efficiently. This function is only effective on
wallpaper affixed using water-soluble adhesive.
The user is liable for improper or non-in-
tended use.
4
Technical data
TP 220
Weight incl. protective cover
Weight excl. protective cover
Length
8
TP 220
Max. perforation depth
5
[1-1]
[1-2]
[1-3]
[1-4]
[1-5]
The specified illustrations appear at the beginning
of the Operating Instructions.
6
Loose wallpaper residue may fall into your eyes!
Wear protective goggles.
Wear suitable protective clothing.
Adjust the length of the telescopic rod.
The telescopic rod can be adjusted to any length.
Adjusting the perforation depth
The plaster / sublayer may be damaged if you
Procedure
1,7 kg
You will obtain better results if you move the de-
1,5 kg
870 - 1370 mm
Machine features
Telescopic handle
Clamp lever for adjusting the length of the
telescopic handle
Perforation depth adjuster
Blade roller
Protective cover
Working
CAUTION
Removing and attaching the protective cover
[Fig. 3].
Open the clamp lever [2-1]!
Pull the telescopic rod to the desired length.
Close the clamp lever [2-1]!
The retaining force of the clamp lever can be ad-
justed using the screw [2-2] while the lever is
closed.
Set to the required perforation depth using the
rotary knob [4-1].
adjust the perforation depth too high. Start with
the lowest setting and increase the perforation
depth if required. One turn of the rotary knob
corresponds to 1 mm.
Place the device in position and roll along the
surface of the wallpaper while applying minimal
pressure.
vice in the direction of the arrow and avoid tip-
ping the perforating head. (see illustration be-
low)
3 mm
Publicité
Table des Matières
