Programming The Control Unit - V2 VEGA-24V Mode D'emploi

18 - PROGRAMMING THE CONTROL UNIT

The configuration menu -PrG consists in a list of configurable items; the display shows the selected item.
By pressing i, you will pass to the next item; by pressing , you will return to the previous item.
By pressing OK, you can view the current value of selected item and possibly change it.
The last menu item (FinE ) allows storing the carried out changes and going back to the control unit normal operation.
You must exit from programming mode through this menu item if you do not want to lose your configuration.
WARNING: in case no operation is carried out for more than one minute, the control unit exits from the programming
mode without saving any of your setups and changes, which will get lost.
By holding down the i or
keys, configuration menu items will scroll fast, until item FinE is viewed.
In this way, you can quickly reach either the top or bottom of the list.
Motor direction
The central unit is set in such a way that the motor turns in the right
direction to open and close a traditional garage door.
If the installation requires the motor's rotational direction to be
inverted, select the inv option.
Opening time
The motor will be operated for the setup time in the opening phase;
in case there is an obstacle or the end of stroke operates, the control
unit can stop the opening phase before the relevant time expires.
Closing time
The motor will be operated for the setup time in the closing phase;
In case there is an obstacle or the end of stroke operates, the control
unit can stop the opening phase before the relevant time expires.
To avoid that the door does not close completely, we recommend to
setup a longer time than t.AP opening time.
Lock time
To pilot an electric lock through the contact on the B1-B2 terminals you
need to set the t.SEr time. This time sets the duration of electric lock
energisation before the door starts opening.
To pilot a door-step lamp through the contact on the B1-B2 terminals
select the no item and configure the LUCI parameter according to the
desired options.
WARNING: the B1-B2 output only provides the closure
of a dry contact.
58