Control Panel; Display; Use Of The Keys For Programming - V2 VEGA-24V Mode D'emploi

9 - CONTROL PANEL

9.1 - DISPLAY

When power is on, the control unit checks that display correctly
operates by switching on all segments for 1.5 sec. 8.8.8.8.
Firmware version, e.g. Pr I.0, will be viewed in the following
1.5 sec.
Panel will be viewed upon completion of this test.
The control panel represents the physical status of the
terminal board contacts and of the program mode keys: if the
upper vertical segment is on, the contact is closed; if the lower
vertical segment is on, the contact is open (the above picture
shows an instance where the inputs PHOTO, EDGE, and STOP
have all been correctly connected).
NOTE: if you are using an ADI module, other segments may
appear on the display, see the paragraph dedicated to the
"ADI INTERFACE"
Points being among display digits show the status of
programming push-buttons: as soon as a push-button is pressed,
its relevant point turns on.
The arrows on the display right side show the door status:
• The highest arrow turns on when the door is into its opening
phase. If it blinks, it means that the opening has been caused
by a safety device (border or obstacle detector).
• The central arrow shows that the door is on pause.
If it blinks, it means that the time countdown for the
automatic closing has been activated.
• The lowest arrow blinks when the door is into its closing
phase. If it blinks, it means that the closing has been caused
by a safety device (border or obstacle detector).

9.2 - USE OF THE KEYS FOR PROGRAMMING

The control unit functions and times are programmed by means
of a special configuration menu, which can be accessed and
explored by using the 3 keys,
under the the control unit display.
The following table describes the functions of the push-buttons:
Press and release the push-button OK
Keep pressed the push-button OK for 2 seconds
Release the push-button OK
Press and release the push-button
Press and release the push-button i (DOWN)
There are the following three kinds of menu items:
• Function menu
• Time menu
• Value menu
Function menu setup
Function menus allow selecting a function from among a group
of available options. When you enter into a function menu, the
current active option will be viewed; you can scroll all available
options through i and
activate the option viewed and you will return to the
configuration menu.
Time menu setup
Time menus allow setting a function duration. When you enter
into a time menu, the current setup value will be viewed; the
display mode depends on the current value:
• times being lower than one minute will be viewed as follows:
each time you press key, current time value increases of
half a second; vice versa, each time you press the i key, current
time value decreases of half a second.
• Times between 1 and 10 minutes will be viewed as follows:
each time you press key, current time value increases of 5
seconds; vice versa, each time you press the i key, current time
value decreases of 5 seconds.
• Times being more than 10 minutes will be viewed as follows:
each time you press key, current time value increases of half a
minute; vice versa, each time you press the i key, current time
value decreases of half a minute.
52
(UP), i (DOWN) and OK, located
(UP)
keys. By pressing the OK key, you will