V2 VEGA-24V Mode D'emploi page 71

DISPLAY DATA DESCRIPTION
AUS Auxiliary channel
tiM - Timed function (from 0 to 20')
biSt - Bistable operation
Mon - Monostable operation
SPiA Setting low voltage exit lights
no - Not used
FLSh - Flasher operation (fixed frequency)
W.L. - Indicator light operation: indicates the status of the door in real-time
LP.PA no / Si Blinker during pause time
Strt Start input function
StAn - Standard operation
no - Start inputs from terminal board are disabled
StoP STOP input
no - STOP input not available
invE - STOP command stops the door: START command starts moving in the opposite direction
ProS - STOP command stops the door: pressing the START command door continues the motion
Foto Photocell input
CFCh - Photocell is active in closing and also when the door is still
no - Not available
Ch - Photocell is active during the closing
Ft.tE no / Si Test of the photocells
CoSt Safety ribbon input
no - Input disabled
AP - Input enabled only in opening phase
Ch - Input enabled only in closing phase
APCh - Input enabled in opening and closing phase
Co.tE Test of the safety edges
no - Test disabled
rESi - Test enabled for conductive rubber safety edges
Foto - Test enabled for optical safety edges
FC.En Limit switch input
StoP - the door stops by the limit switches
rALL - the door begins the slow-down stage (t.rAL menu) by the limit switches
- the "shadow area" function is activated when the LEFT micro switch trips and disabled
ShAd
when the RIGHT micro switch trips
no - Inputs disabled
riLA 0 ÷ 10 Motor release on mechanical stop
i.Adi no / Si Enabling the ADI device
CFG Mt / SL Control unit setting
FinE End programming.
no - Do not exit the programming menu
Si - Exit from the programming menu, storing the parameters set
69
MEMO
DEFAULT
DATA
tiM
W.L
no
StAn
no
CFCh
no
no
no
StoP
2
no
Mt
no