Follow-Up» Mode - Microlife WatchBP Office Mode D'emploi

«FOLLOW-UP» Mode
1) Turn on the power – Turn on the device by
switching the I/O switch at the back of the device
to the ON position and make sure Bluetooth
switch is in off position.
DC 6V 600mA
AUSCULT 1st FOLLOW UP
2) Apply the cuff – Properly fit one cuff to the
preferred measurement arm.
Additional visual instruction can be found on the cuff
*
DC 6V 600mA
AUSCULT 1st FOLLOW UP
3) Switch to «FOLLOW-UP» Mode – Slide the Mode
Switch to «FOLLOW-UP» Mode.
AUSCULT 1st FOLLOW UP
4) Select the inflation cuff – Set the device to
inflate only the designated (right or left) cuff.
Press and hold the M Button for 3 seconds.
Press and hold
for 3 seconds...
18
EN