Krups Prep&Cook XL Mode D'emploi page 95

PROBLEMS
"SECU" is displayed
+ red indicator light is
flashing.
"Err1" is displayed.
+ red indicator light is
flashing.
"Err2" is displayed.
"Err3" is displayed.
"Err4" is displayed.
Display "Err8"
"ntc1" is displayed.
"ntc2" is displayed. +
red indicator light is
flashing.
Safety indicator
display (C5)
The safety lock on the
lid remained active
(rod extended) and
prevents the lid from
locking.
Is your appliance still not working?
Contact an approved service centre (see list in service booklet).
„ Elimination of packaging and appliance materials.
The packaging exclusively contains materials that are not dangerous to the envi-
ronment, which can be disposed of in accordance with the recycling regulations
in force.
To dispose of your appliance, ask the appropriate department of your local authority.
„ End-of-life electronic or electrical appliances:
Environmental protection first!
Your appliance contains numerous materials that can be recovered or recycled.
Take it to a collection point for processing.
CAUSES
Overheating of temperature
sensors.
The heating element is not
working.
Electronic fault.
Speed fault.
Communication fault with
chopper electronic card.
Safety locking sensor fault
Temperature sensor 1 is no
longer working.
Temperature sensor 2 is no
longer working.
Improper locking of the bowl
or lid
The lid is locked on the bowl in
the "cooking without a lid" mode
The appliance was turned off
as a recipe was in progress
by toggling the I/O switch to
the "O" position or was simply
unplugged as a recipe was in
progress.
RECYCLING
SOLUTIONS
Contact an approved service centre.
Check that the power pins under the
bowl are not clogged. If this is the case,
clean them and try again.
If that still does not work, contact an
approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an Approved Service Centre.
Contact an approved service centre.
Contact an approved service centre.
Prior to operating the appliance, check
that the bowl is properly locked on the
motor unit and that the lid is properly
locked on the bowl. If the problem
persists, contact an authorised centre.
Unlock the lid prior to launching the
cooking program. If the problem persists,
contact an authorised centre.
Simply toggle the I/O switch to the "I"
position to reset the food processor,
along with the safety lock on the lid; the
rod will automatically return to its original
position. You may now lock the lid.
95