Krups Prep&Cook XL Mode D'emploi page 93

WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK
PROBLEMS
Insufficient cooking time.
Problems when steam
cooking.
The steam regulator cap is not
properly positioned or is missing.
Poor cooking results
Unsuitable recipes
in Manual mode
It is not plugged in.
The switch (H) is in position 0.
The appliance does not
work.
The bowl or the lid are not
correctly positioned or locked.
The lid does not lock. The lid is not fully assembled.
CAUSES
Cooking times are only a guide and
approximate. However, certain conditions
may affect the cooking time:
- size of the vegetables (cut or uncut)
- quantity of ingredients in the basket
- type of vegetables, their ripeness
- quantity of water in the bowl, which cor-
responds to the measurement (0.7l).
If the food is not properly cooked, you can
set an additional cooking time.
You can also use the manual mode by
selecting a temperature of 130°C and the
cooking time according to the quantity
and type of ingredients.
Set the steam regulator cap to 'maxi
steam' (turn towards you); this setting
allows a maximum amount of steam
to build up in the bowl for all types
of steam cooking (soups, etc.), so
there will be more steam in the bowl
and the cooking process will be more
efficient. This position also helps to
avoid splashing during cooking. The
'mini steam' position allows a maximum
amount of condensation to escape and
is recommended when making sauces
and dishes such as risotto, egg custard
desserts, etc.
The "zero" position is used to fasten and
remove the lid steam regulator stopper.
Your recipes, either personal or taken from
the Internet may not be suited to your
appliance and its accessories (quantities,
cooking time, duration, inadequate
accessories). Before starting your recipe,
make sure you follow the instructions of
use provided in this manual.
Plug the appliance into an electrical
socket.
Move the switch to position 1.
Check that the bowl or the lid are correctly
positioned and locked according to the
diagrams in the instruction manual.
Check that the seal is correctly
assembled on the seal holder and that
the seal holder is fully pushed onto the lid
in all places.
SOLUTIONS
93