Krups Prep&Cook XL Mode D'emploi page 94

PROBLEMS
Excessive vibration.
Slight noise during
operation
Excessive noise during
operation
Leak through lid.
Leak from the driver in
the bowl or from the
XL base accessory.
The blades do not
rotate easily.
Smell from motor.
"STOP" is displayed.
"SECU" is displayed.
94
CAUSES
The appliance is not positioned
on a flat surface, the appliance is
not stable.
Volume of ingredients too high.
Accessory error.
The spindle of your appliance
may create a noise during
operation at reduced speed
or with the use of certain
ingredients (rice...)
The use of a wrong accessory
Volume of ingredients too high.
The lid is not correctly positioned
or locked.
The lid seal is not present.
The lid seal is cut or damaged.
Accessory error.
The bowl seal (D4) is not
correctly positioned.
The bowl seal is damaged.
The locking ring (D6) is not
locked correctly.
Pieces of food that are too big or
too hard.
On using the appliance for the
first time, or in the event of
overload of the motor caused
by too large a quantity of
ingredients or by pieces that are
too hard or too big.
The appliance has detected
too many vibrations and has
changed to the safety mode.
Motor overload caused by too
many ingredients or pieces
which are too hard or too large
or overuse without sufficient
cooling down time.
SOLUTIONS
Place the appliance on a flat surface.
Reduce the quantity of ingredients
processed.
Check that you are using the
recommended accessory.
This is a temporary phenomenon, which
has no consequences on the life of your
appliance. It will fade or disappear after a
few uses and cleaning operations of the
removable spindle (refer to the paragraph
"Cleaning the appliance").
Please use an adequate accessory (e.g.:
do not use the beater F3 for kneading or
mixing the dough, use the knife F4). For
this, refer to the recommendations in the
recipes and the operating instructions
provided in this manual.
Reduce the quantity of ingredients
processed.
Lock the lid correctly on the bowl.
Position the seal on the seal holder and
clip the assembly to the lid.
Change the seal, contact an approved
service centre.
Check that you are using the
recommended accessory.
Position the seal correctly.
Contact an approved service centre.
Screw the ring in place (D6).
Reduce the size or quantity of the
ingredients processed. Add some liquid.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Check that you are at the right speed
and that you are using the recommended
accessory.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.