Filter Holder - Rowenta PERFECTO COMBI ES4210 Mode D'emploi

RO_COMBI_NC00025872-01_EO_rowenta 20/09/11 17:34 Page25
B.

Filter holder

Your appliance is equipped with a removable filter ejecting holder,
which we recommend that you maintain in perfect working
condition. We recommend that you clean it after each use. These
removal/fitting operations must be carried out when the machine has
EN
cooled down.
1. Removing the filter holder:
• Remove the filter holder from your machine.
• Dispose of the used grounds or pod by pressing the
button
• Rinse under running water.
• Remove the bottom of the filter holder by rotating
clockwise while turning the 2 fixed coffee outlets.
2. Cleaning and rinsing the filter holder:
The filter holder may then be cleaned using a household
washing-up liquid and a scourer; it should be rinsed afterwards
with running water. For best results, you may press the eject
button several times while rinsing. We recommend shaking the
filter holder vigorously in order to release any water that may
have collected inside.
3. Fitting the filter holder:
Replace the bottom of the filter holder by turning it anticlockwise
to lock it in place.
C. The drip tray
When the level gauge indicates that the drip tray is full, it must be
emptied after first removing the grid (Fig. 18). The presence of water
is normal and is not the sign of a leak. If required, clean the drip tray
and its grid with water and a little non abrasive detergent. Rinse and
dry.
D. Steam nozzle (Figs 25a, 25b)
This accessory consists of 2 parts: one part which is the plastic
support and the other which is the metal protection cylinder.
Before cleaning, unlock the nozzle from the articulated arm by
turning it to the left.
Then slide the metal cylinder along the plastic support.
Clean these two parts with tap water and some mild washing-up
liquid.
(Fig. 15).
25
"Push"