Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RO_COMBI_NC00025872-01_EO_rowenta 20/09/11 17:34 Page22
•
Release the filter holder by pressing the
turning it towards the left
place the ground coffee into the filter holder: one measuring
spoon (filled to the top) per cup for a good espresso
•
Remove any excess ground coffee from the edge of the filter
holder
•
Insert the filter holder in the appliance by turning it to the right
up to the stop
•
Put one or two cups on the drip tray grid under the filter holder
(Fig.
12).
•
Turn the selector dial
•
After a few moments, the coffee will start to flow.
•
When your cups are full, move the selector
(Fig.
6).
•
Remove the cups.
•
Unlock the filter holder: press the
the filter holder to the left and remove it from the appliance. Throw
away the used grounds using the ejection system by pressing the
"Push"
button under the filter holder
under running water, pressing the
remaining grounds (see also Paragraph
cleaning).
It is normal that every time the selector dial
there is a slight noise of running water or steam. This is due to a specific
device which eliminates the pressure built up within the system.
With an E.S.E espresso pod
"ESE" for "Easy Serving Espresso" is a packaged pod (44 mm
diameter) of 7g of selected coffee, ground and compacted
between two paper filters, specially designed to make Italian style
ristretto (small and strong) espressos. This system allows an
immediate, simple, clean and comfortable use of your machine.
•
Before removing the water tank, remember to place the selector
dial
d1
•
Fill the tank with cold water and fit it back into the appliance
•
Switch on the appliance by pressing the on/off button
•
The light flashes during the preheating phase and then remains
lit. The appliance is then ready for use.
•
Unlock the filter holder by pressing the
turning it towards the left
excess paper around the pod following the dotted lines
(Fig.
9b).
(Fig.
11).
d1
to the position
in the
position
(Fig.
8). Using the measuring spoon,
(coffee)
d1
button lightly while turning
(Fig.
15). Wash the filter holder
"Push"
button to eliminate the
8.B
for a more thorough
d1
returns to the
(Fig.
6).
(Fig.
14). If required, remove the
22
button lightly and
(Fig.
9a).
(Fig. 4).
to the
position
position
(Fig.
7).
d2.
button lightly and
(Fig.
13).
EN
Publicité
Table des Matières
