Getting Started - Unpacking; Additional Safety Instructions For Circular Saws - Evolution S185 Notice Originale

www.evolutionpowertools.com
angles and depths of cut.
b) Check the operation of the lower guard
spring. If the guard and the spring are not
operating properly, they must be serviced
before use. Lower guard may operate
sluggishly due to damaged parts, gummy
deposits, or a build-up of debris.
c) The lower guard may be retracted
manually only for special cuts such as
"plunge cuts and "and "compound cuts".
Raise the lower guard by the retracting
handle and as soon as the blade enters the
material, the lower guard must be released.
For all other sawing, the lower guard should
operate automatically.
d) Always observe that the lower guard is
covering the blade before placing the saw
down on bench or floor. An unprotected,
coasting blade will cause the saw to walk
backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop
after switch is released.
ADDITIONAL SAFETY
INSTRUCTIONS
FOR CIRCULAR SAWS
a) Do not use High Speed Steel (HSS)
saw blades.
b) Inspect the machine and the blade
before each use. Do not use deformed,
cracked, worn or otherwise damaged blades.
c) Never use the saw without the original
guard protection system. Do not lock
the moving guard in the open position.
Ensure that the guard operates freely
without jamming.
d) Only use blades that comply with the
characteristics specified in this manual.
Before using accessories, always compare
the maximum allowed RPM of the
accessory with the RPM of the machine.
e) Do not use any abrasive wheels.
f) Use only blade diameter(s) in accordance
with the markings.
WARNING: If any parts are missing, do
(3.4)
not operate your machine until the missing
parts are replaced. Failure to follow this rule
could result in serious personal injury.
GETTING STARTED -
(4.1)
UNPACKING
Caution: This packaging contains sharp
objects. Take care when unpacking. Remove
the machine, together with the accessories
supplied from the packaging. Check carefully
to ensure that the machine is in good
condition and account for all the accessories
listed in this manual. Also make sure that all
the accessories are complete.
If any parts are found to be missing, the
machine and its accessories should be
returned together in their original packaging
to the retailer.
Do not throw the packaging away; keep it
safe throughout the warranty period. Dispose
of the packaging in an environmentally
responsible manner. Recycle if possible.
Do not let children play with empty plastic
bags due to the risk of suffocation.
ITEMS SUPPLIED
(4.2)
Description
Instruction Manual
Mild Steel Cutting TCT Blade
Hex Key (Blade Change)
Parallel Edge Guide
Evolution Instruction Manuals
4.3)
Evolution Power Tools provides each product
with an Instruction Manual.
Each dedicated manual is carefully constructed
and designed to provide easily accessible and
useful information regarding the safe use, care
and maintenance of the product. Referencing
the information contained within the manual
will allow the operator to fully and safely
exploit the potential of the machine.
Evolutions policy of continual product
development may mean that, very
occasionally, the contents of a manual may not
completely reflect the latest improvements or
upgrades that have been incorporated into a
particular product. Upgrades/improvements
to the specification of a product could come
about as a consequence of technological
advances or changes to the legislative
framework of the receiving country, etc.
If you are at all unsure about any aspect of
the use, care or maintenance of an Evolution
product, contact the relevant Evolution
helpline where up to date information and
extra advice will be available.
9
CCSL
1
EN
1
1
1