General Information; Exchanging Rotors - StarLab N2631-0007 Mode D'emploi

ENGLISH
STARLAB MICROCENTRIFUGE
Cat. No. N2631-0007

General Information

The STARLAB Centrifuge is supplied with two rotors; one (standard) for microtubes, and one (strip) for
0.2ml PCR single or strip tubes. The standard rotor is designed to centrifuge up to six individual 1.5/2.0ml
plastic microcentrifuge tubes, and will also accept 0.4ml/0.5ml tubes when used with the adapters sup-
plied.
The strip tube rotor is designed to centrifuge two 8 x 0.2ml strip tubes and will also accept up to 16
individual 0.2ml tubes. Both rotors are designed for applications requiring relatively low g-forces, such
as microfi ltration, cell separation and quick spin downs from the walls of tubes. Please read this manual
thoroughly before attempting to operate the centrifuge.
Warranty
The centrifuge and rotor are covered by a one-year warranty which covers the centrifuge and
rotor. This warranty is void in the event of incorrect operation, use of non-standard spare parts or
accessories, and unauthorised modifi cation of the rotor or centrifuge. The rotor warranty does not cover
normal wear and tear, nor does it cover damage and/or weakening caused by radioactive contamination,
cleaning agents, or overtightening of the allen screw. Fuses are not covered by the warranty.

Exchanging Rotors

The rotors are easily exchanged using the allen wrench provided. Locate the set screw on the rotor shaft
below the rotor head. Using the wrench, loosen the set screw and pull up the rotor to remove. Place the
other rotor into position on the motor shaft. Take care not to press the rotor down so far as to compress
the rubber collar at the base of the shaft. Tighten the screw using the allen wrench until fi nger tight. Do
not overtighten as this will cause damage to the rotor and the motor shaft.
STARLAB Microcentrifuge 3