BORETTI VFPNR-94 AN Mode D'emploi page 96

Malfunction
The burner switches off as
soon as the knob is released.
The burner switches off as
soon as the knob is released
after 10 seconds.
The burner switches off in the
lowest position.
The spark ignition keeps
clicking.
Ceramic Cooktop:
Malfunction
Half of the zones do not work.
Half of the zones do not work.
If your malfunction has not been solved using the overview above, you can report
it on the Boretti website. You can also call +31(0)20-4363525.
Possible Cause
The thermocouple is not hot
enough.
The knob has not been pushed
down far enough.
The lowest position has been
adjusted too low, so that the
thermocouple is not hot enough.
The ignition switch is wet (be-
cause of food spills or cleaning).
Possible Cause
One of the groups has not been
connected properly.
Something is wrong with one of
the fuses.
Solution
After the flame has been lit,
keep the knob firmly pressed
down for another 8 to 10
seconds.
Try again, and keep the knob
firmly pressed down.
Set the lowest setting a little
higher, see section about
adjusting the lowest position.
The ignition will continue to
click until all the moisture has
dried up. This is not harmful,
but it is annoying. In order
to have the switch dry more
quickly, it will help to switch
on the oven to its highest
temperature.
Solution
Check the connection and
tighten the screws.
Replace the fuse in question in
the fuse box.
NL
FR
DE
EN
97