Function Push Buttons; Identification Label - golmar V2PLUS Manuel D'installation

96
F
unction push buttons
Regardless of the handset's position, it activates the PA and PB voltage-free contacts The
JP2 jumper must be inserted (see page 108
jumper is inserted (see page 108), this second process taking place during call
reception or communication.
If the handset is on the craddle allows to see the picture from
If the handset is picked up, audio and video communication can be established with the
door panel (
there is communication already in progress
D uring call reception and communication processes, it allows lock release activation
E
nd of line and amplifying the video signal
Factory default
D
escription of the identification label
PLATEA V2PLUS
VERSIÓN:
X.XX
INTER A1 SLAVE MASTER
ATENCIÓN
Alta tensión. No abrir la tapa. ESCALERA
Manipular sólo por personal
STAIR
del servicio técnico.
WARNING
High voltage. Don't open cover.
Handle only by technical service.
.
the autoswitch-on function must be activated This function is disabled if
The Sw2 configuration dip switch is located
on the rear of the monitor .
No function.
No function.
Set to ON to configure with the end of line resistor in monitors where bus
wires terminate .
Set to OFF only for intermediate monitors
No function.
Set to On the monitors:
That distance is more than 65 m. from door panel or multiplexer.
Connected from output No. 20 of the disributors (with door panel or
multiplexer).
In an installation without distributors (daisy chain) from monitor No.9 or
at a distance of more than 80m. from door panel or multiplexer.
Set to OFF the rest of monitors.
.
For an easiest repair, replacement or increasement
REF.
COD.
11784042
MASTER: m
Nº SERIE:
SLAVE:
00000000000
INTER:
CODIGO / CODE
A1:
PISO PUERTA
FLOOR DOOR
CODE:
STAIR:
MONITOR DESCRIPTION
), or activate the SAR-2Plus unit if the JP1
the door panel
.
.
.
of the existing monitors, fill the identifying label
information .
aster monitor .
slave monitor 1 or slave monitor
no function .
no function .
push button code (see page
no function .
.
).
.
2.
91).
.